Do all operators have to be trained?

According to regulations, each individual that operates mobile equipment must be trained and certified prior to operating the equipment in the workplace. This applies to experienced operators, new or part-time employees and contractors.

When do operators need re-training?

Most North American regulatory authorities mandate that an operator be re-trained and certified every three years. Re-training and certification is also required when:

What is criminal negligence?

The act of being criminally negligent is knowing that the task(s) or operation(s) performed is unsafe or against the regulatory requirements. In other words, recklessly acting without reasonable caution and putting another person at risk of injury or death.

What is the training standard?

Depending on the mobile equipment, the standards that are referred to by Regulations are the CSA and ANSI standards. (Canadian Standards Association and American National Standards Institute

What is due diligence?

Taking all reasonable care to protect the well being of employees or co-workers.

When does the operator need to inspect the equipment?

As per regulations, each and every operator, prior to operating the equipment, must conduct a pre-operational inspection. The pre-use inspection must be documented and retained by the company for a minimum of one year. The equipment should not be used if any items on the pre-use inspection indicate that the equipment is in an unsafe condition or that the equipment is not operating as per the conditions of the manufacturer.

When does the operator need to inspect the equipment?

As per regulations, each and every operator, prior to operating the equipment, must conduct a pre-operational inspection. The pre-use inspection must be documented and retained by the company for a minimum of one year. The equipment should not be used if any items on the pre-use inspection indicate that the equipment is in an unsafe condition or that the equipment is not operating as per the conditions of the manufacturer.

Can our company modify or repair our equipment?

The only personnel that should attempt to modify or repair the equipment is a mechanic certified by the manufacturer. Before any attempts are made by the company, ensure that you have documentation from the manufacturer stating the company can repair/modify the equipment.

Saturday Training - Onsite Equipment Training Services

About -
Blog -
FAQ -

Saturday Training

I was at the Center Point, SNC Lavalin jobsite on Saturday, doing aerial boom training for Labourer’s Union, Local 1258. Great group of guys! Most were beginners, but definitely willing and able to learn. One thing that I stressed to the guys is that they have to get as much running time on the machine as possible and to make sure that they don’t allow too much time lapse in-between our training and getting on the boom-lift.

Rough Terrain Forklift Training Guide
My Tips For Operating A Rough Terrain Forklift
Key documentation elements
Forklift Certification Manitoba
Saturday Training

Are You Looking For Operator or Trainer Training?

GET A QUOTE

Recent Posts

Categories

Are You Looking For Operator or Trainer Training?